S100
1-35
Revised 10/2005
e-mail: [email protected] ; [email protected] ; website: www.amfreece.com
Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
D - MACHINE ADJUSTMENT
1 0 . T U R N I N G M E C H A N I S M
WA R N I N G !
This adjustment can be performed only by well trained mechanic.
If the stitches are not vertical to the catted hole, it is necessary to adjust the turning mechanism:
1.
The machine must be in home position.
2.
Loosen the screw and adjust the looper holder, so that the looper holder is vertical to the length
ways axis of the table. Tighten the screw .
3.
Loosen the screw
and adjust the needle bar so that tension discs are in direction towards the
operator. Tighten the screw .
If the stitches are not in direction to the centre of the eye, follow this steps:
1.
Lift the machine head.
2.
Loosen the nut on the roller stud
of the turn lover according to the necessity. By moving down
direction
2
, turning starts earlier and by moving up direction
1
, turning starts later. Tighten the
nut stud .
Turning
segment
Turning lever
Roller stud
Rod stud
1
2
Turning
segment
3
4
Check the correct position by means of the enclosed gauge from accessories.
Give down the machine head. Remove the stitching plate. By turning the handle on the machine left side, go
with the table to the half of the sewn buttonhole in the first row of stitches.
1
2