AMCI ANS1 ANYNET-I/O, User Manual

Page: 72 / 90

Output Data Format
ADVANCED MICRO CONTROLS INC.
5
72
Command Block 15: Save/Restore Program
This block allows you to save module programming to the internal memory of the ANS1. You can also use
this block to restore a program, which allows you to program the ANS1 on power up with a single command.
Figure 5.15 Command Block 15
Command Word Bits
Bit 5: Delete All Programs. Setting this bit to ‘1’ will delete all programs stored in the ANS1. Parameter
values of the active program will remain in RAM. If power is cycled before these parameters are
saved to a program, the ANS1 will power up with factory default settings.
Bit 8: Load Program. Setting this bit to ‘1’ will load the program into memory that is defined by word 1.
This bit and bit 9 cannot be set at the same time.
Bit 9: Save Program. Setting this bit to ‘1’ will save the present programming into the program that is
defined by word 1. This bit and bit 8 cannot be set at the same time.
Bit 10: Save Global Parameters. Setting this bit to ‘1’ will save the Global Machine Configuration and
Brake Monitor Setup parameters to FLASH memory. The Global Machine Configuration parameters
are programmed using command block 2 as described starting on page 56 and the Brake Monitor
Setup parameters are programmed using command block 8 as described starting on page 67.
Word 1 Values
The FLASH memory used on the ANS1 is limited to 100,000 write cycles. Exceeding this
value may cause damage to the module.
EtherNet/IP
Address
Modbus
Address
Bit Number
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0 1024
T
ransmit Bit
0 0 0 0
Save Glob
al
Save P
rgm
Load Pr
gm
0 0
Delete Al
l
Clear Error
1 1 1 1
1 1025
Program Number to act on (Range of 0, 1-39, 40)
See description below
2-19 1026-1043 Not Used
Word 1 Value Program
0
Active Program

When reading a program from memory, this block will have no effect.

When saving a program to memory, the last program read from memory

will be stored to.
1 - 39 Program Number
40
Factory Default

Used when reading a program only. This value will restore factory defaults for

all parameters in RAM.