AMCI ANS1 ANYNET-I/O, User Manual

Page: 46 / 90

Installing the ANS1
ADVANCED MICRO CONTROLS INC.
4
46
Relay Board Installation (continued)
DIN Rail / Panel Mount Conversion
The relay boards can be DIN rail or panel mounted and require a +24Vdc supply for operation. They are
shipped from AMCI in their DIN rail mount configuration and can be mounted on EN 50 022 or EN 50 035
channel. The procedure for converting them to panel mount is given below.
Figure 4.9 Panel Mount / DIN Rail Conversion
RB-7 Outline Drawing
Figure 4.10 RB-7 Outline Drawing
1) Remove the two hex head screws that
hold the panel mount bracket in place.
2) Remove the DIN rail adapter bracket.
3) Reverse the panel mount bracket and
re-install it with the two hex head screws.
4) Repeat on the other side.
Panel Mount Bracket
DIN Rail Adapter Bracket
Hex head Screw
BOTTOM VIEW OF RELAY BOARD
(INCOMPLETE)
U U U U U U U U
K1 K2 K3 K4 K5 K6 K7 K8
U
FUSE
TESTER
DS1
F1
SPARE FUSE
FROM
MODULE
CN1
+ + + +
4/12
+
5/13
+
6/14
+
7/15
+
8/16 COM +24V
GND
E1
8.25 in
2.25" max.
(57.2)
2.85" max.
(72.4)
2.50" typ.
(63.5)
1.77" typ.
(45.0)
3.80"
(96.5)
0.65" (16.5) typ.
7.999 in
8.00" (203.2) Suggested Mounting Dimension
7.7" (196) typical dimension with brackets reversed)
1/9 2/10 3/11