AMCI ANS1 ANYNET-I/O, User Manual

Page: 68 / 90

Output Data Format
ADVANCED MICRO CONTROLS INC.
5
68
Command Block 9: Program Shift Register Parameters
This block allows you to program the shift register parameters. An explanation of the Shift Register function
can be found in the
Shift Register ANDing section of the manual starting on page 25.
1) This block only programs the shift register parameters. Command Block 6: Program LS
Enabling Parameters on page 62 is used to program which shift register bit is used to control
an output.
2) If the Shift Register is disabled, all outputs that have a shift register bit assigned to them will
be disabled.
Figure 5.12 Command Block 9
Command Word Bits
Bit 5: Delete All Shift Register Data. Setting this bit to ‘1’ will delete all of the parameter values associated
with the Shift Register and disable it.
Bit 8: Program Shift Register Parameters. If this bit is reset to ‘0’ the shift register parameter are left at
their previous values. If this bit is set to ‘1’, words 1 through 4 are used to program the shift register
parameters.
EtherNet/IP
Address
Modbus
Address
Bit Number
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0 1024
T
ransmit Bit
0 0 0 0 0 0
Ap
ply
W
o
rd
s
1-4
0 0
Delete All
Clear Error
1 0 0 1
1 1025
Shift Register Input (Range of 0, 1 to 16)
If ‘0’, the shift register function is disabled
2 1026 Shift Register FROM setpoint (Range of 0 to ( Full Scale Count -1))
3 1027 Shift Register TO setpoint (Range of 0 to ( Full Scale Count -1))
4 1028 Shift Position (Range of 0 to ( Full Scale Count -1))
5 - 19 1029-1043 Not Used