General safety instructions
•
When coupling and uncoupling machines, move the support
equipment (if available) to the appropriate position (stability).
•
When actuating the support equipment, there is a risk of injury
from crushing and cutting points.
•
Be particularly careful when coupling the machine to the tractor
or uncoupling it from the tractor. There are crushing and cutting
points in the area of the coupling point between the tractor and
the machine.
•
It is forbidden to stand between the tractor and the machine
when actuating the three-point linkage.
•
Coupled supply lines
ο
must give slightly to all movements while cornering without
tensioning, kinking or rubbing.
ο
must not chafe against other parts.
•
The release ropes for quick couplings must hang loosely and
must not release themselves when lowered.
•
Also ensure that uncoupled machines are stable.
Use of the machine
•
Before starting work, ensure that you understand all the equip-
ment and actuation elements of the machine and their function.
There is no time for this when the machine is already in opera-
tion.
•
Do not wear loose-fitting clothing. Loose clothing increases the
risk of being caught by the drive shaft.
•
Only start-up the machine, when all the safety equipment has
been attached and is in the safety position.
•
Comply with the maximum load for the connected machine and
the permissible axle and drawbar loads for the tractor. If neces-
sary, drive only with a partially filled tank.
•
It is forbidden to stand in the working area of the machine.
•
It is forbidden to stand in the turning and swivel range of the
machine.
•
There are crushing and cutting points at externally-actuated (e.g.
hydraulic) machine points.
•
Only actuate externally-actuated machine parts when you are
sure that no-one is standing within the prescribed safety dis-
tance.
•
Before leaving the tractor, secure it against unintended starting
and rolling.
To do this:
ο
lower the machine onto the ground
ο
apply the parking brake
ο
switch off the tractor engine
ο
remove the ignition key
28
BAG0021.14 05.19
Summary of Contents for UG 2200 Special
