Using the machine
10.3.1
Filling the spray liquid tank via the filling opening
1. Determine the precise water filling quantity (refer to the section
"Calculating the filling quantity or re-fill quantity", page 163).
2. Open the hinged/screw lid on the filling opening.
3. Fill the spray liquid tank via the filling opening with a "free flow"
from the mains water supply.
4. Always pay attention to the fill level indicator during filling.
5. At the latest, you should stop filling the spray liquid tank
•
when the pointer on the fill level indicator reaches the fill
limit mark.
•
before the field sprayer's authorised load is exceeded by
the quantity of liquid poured in.
6. Close the filling opening properly using the hinged/screw lid.
10.3.2
Filling the spray liquid tank via the suction port on the control terminal
WARNING
Damage to the suction valve chest caused by pressure filling via
the suction connection!
The suction connection is not suitable for pressure filling. This also
applies for filling from a higher-elevation source.
Please observe the relevant instructions when filling the spray liquid
tank via the suction hose from public water points (please also see
the section "Use of the machine", page 160).
•
When filling, keep the cover open to allow the pressure to equal-
ise!
•
Always pay attention to the fill level indicator during filling.
•
At the latest, you should stop filling the spray liquid tank
ο
when the pointer on the fill level indicator reaches the fill
limit mark.
ο
before the field sprayer's authorised load is exceeded by
the quantity of liquid poured in.
BAG0021.14 05.19
167
Summary of Contents for UG 2200 Special
