Coupling and uncoupling the implement
ED 02 BAH0023.0 03.14
87
7.6
Uncoupling the implement
WARNING
Risk of contusions, cutting, catching, drawing in and knocks
through insufficient stability and possible tilting of the
uncoupled implement!
Set the empty implement down on a level parking area with a firm
base.
When uncoupling the implement, there must always be enough free
space in front of the implement that the tractor can be aligned with the
implement again during recoupling.
1. Switch off the control terminal (if fitted).
2. Put the support legs into the support position [see section
"Supports", Seite 86] and park the implement.
3. Turn off the PTO shaft, apply the hand brake, switch off the
tractor engine, and remove the ignition key.
4. Uncouple the implement from the tractor.
4.1 Relieve the top links.
4.2 Unlock and uncouple the top link hooks from the tractor
seat.
4.3 Relieve the lower links.
4.4 Unlock and uncouple the lower link hooks from the tractor
seat.
4.5 Drive the tractor approx. 25 cm forwards.
→
This will allow more clearance between tractor and
implement and give better access for uncoupling the supply
lines.
4.6 Secure the tractor and implement against unintentional
start-up and rolling.
4.7 Depressurise the tractor's hydraulic system.
4.9 Uncouple the supply lines.
4.10 Close the hydraulic connectors with the protective caps.
4.11 Fasten the supply lines in their respective parking sockets.
5. Uncouple the PTO shaft halves on the tractor side. Support the
PTO shaft on the PTO shaft support (Fig. 63/2).
DANGER
While pulling the tractor forwards no personnel are allowed to be
between the tractor and the implement!
