Coupling and uncoupling the implement
ED 02 BAH0023.0 03.14
79
5. The implement is fitted with category II
lower and top link pins.
Fit the lower and top link pins with bearing
sleeves (Fig. 64).
The bearing sleeves used depend on the
type of the tractor (see the tractor's
operating instructions).
It is imperative to adapt the category II top
and lower pins of the implement using the
reducing sleeves to category III if your
tractor has a hydraulic three-point category
III system.
6. Secure the top and lower link pins (linch pin
securing pins).
7. Direct people out of the danger area
between the tractor and implement before
you approach the implement with the
tractor.
8. First connect the supply lines (see section
7.2, Seite 82 and section 7.3, Seite 85)
before coupling the implement to the
tractor.
8.1 Drive the tractor towards the
implement leaving a gap (approx. 25
cm) between the tractor and the
implement.
8.2 Secure the tractor against
unintentional starting and rolling away.
8.3 Check that the tractor's PTO shaft is
switched off.
8.4 Connect the supply lines to the tractor.
ο
Make the hydraulic connections (see
section 7.2, from Seite 82).
ο
Make the electrical connections (see
section "Electrical connections", Seite
85)
8.5 Position the lower link hooks so that
they are aligned with the lower pivot
points on the implement.
Fig. 64
