Settings
ED 02 BAH0023.0 03.14
137
8.19
Adjusting the fertiliser coulters
1. Loosen the nut (Fig. 153/1) to move the
fertiliser coulter horizonally on the
clamping rail. The distance to the seeding
coulter is set at the factory to 6 cm.
2. Remove the R clip and the pin (Fig. 153/2)
to adjust the placement depth of the
fertiliser coulter.
Fig. 153
The hoses to the fertiliser coulters must not hang down, so that
no fertiliser can settle in the hose.
If required, shorten the fertiliser hoses!
Check that the nuts (Fig. 153/1) are firmly seated after 10 operating
hours (tightening torque 200 Nm).
8.19.1
Adjusting the furrow former on the fertiliser coulter
Adjusting the distance from the furrow former to the cutting disc.
Fig. 154
1. Loosen the lock nut (Fig. 154/1),
2. Undo the fixing bolts (Fig. 154/1),
3. To adjust, screw in the fixing bolts (Fig.
154/1),
4. Adjust the distance from the furrow former
to the cutter disc to 1 to 2 mm
(Fig. 154/2),
5. Tighten up the lock nut.
