Settings
ED 02 BAH0023.0 03.14
119
8.11.2.1 Adjusting the fan speed via the flow control valve of the tractor
1. Fill all seed hoppers.
2. Unscrew the lock nut (Fig. 117/1).
3. Close the hand wheel (Fig. 117/2) (turn
clockwise) and finally open it by 1/2 a turn
so that the oil supply amount is as small as
possible. Larger oil supply amounts, unless
absolutely essential, should be avoided.
4. Secure the hand wheel with the lock nut
(Fig. 117/1).
5. Start the tractor engine and run at high
rpm.
6. Turn the drive wheel with the hand crank
until all the holes of the singling discs are
filled with seed grains (see section "Check
the scraper position and the reduction flap
position", Seite 113).
7. Adjust the fan speed using the pressure
gauge (Fig. 113) on the flow control valve
of the tractor.
Fig. 117
8.11.2.2 Adjusting the fan speed via the flow control valve of the implement
The fan speed can only be adjusted on the flow
control valve of the implement, when the tractor
does not have a flow control valve.
Adjusting the fan speed on the flow control valve
of the implement.
1. Fill all seed hoppers.
2. Start the tractor engine and run at high
rpm.
3. Unscrew the lock nut (Fig. 118/1).
4. Turn the drive wheel with the hand crank
until all the holes of the singling discs are
filled with seed grains.
5. Turn the hand wheel (Fig. 118/2) until the
pointer of the pressure gauge (Fig. 113) is
in the green area.
6. Secure the hand wheel with the lock nut
(Fig. 118/1).
Fig. 118
