CPU-XL VariSpark IOM 07-21
All rights reserved © ALTRONIC, LLC 2021
23
24.0 SETUP CONTROL OPTIONS
24.1 Additional control settings and display features can be accessed under the setup
menu. Changes made under the Setup menu are stored in EEPROM and remain
fixed until changed again. The Setup menu can be entered as described below.
FROM
PRESS
SETUP
24.2 The next setup screen is used to adjust the engine overspeed setpoint. The
setpoint can be adjusted in increments of 5 rpm to a maximum of 1275 rpm.
AT
TO
TO
FOR
TO
INCREASE
DECREASE
NEXT
EXIT
OPTION
NEXT
ESC
24.3 The next setup screen is used to specify the exact position of the reset pin. Both
the reset position and the engine timing are displayed. Adjustments are made
here to make the displayed timing match the actual spark timing as verified with
a timing light. This adjustment effects the displayed timing but does NOT change
the actual timing of the firings.
AT
TO
TO
FOR
TO
INCREASE
DECREASE
NEXT
EXIT
OPTION
NEXT
ESC
⬆
⬇
NOTE: Reset position must be se-
lected and properly documented by
the originator.
NOTE: Adjustment of this parameter
should be done while individual cylin-
der offsets are all at zero.
⬆
⬇
Summary of Contents for VariSpark CPU-XL
Page 88: ...CPU XL VariSpark IOM 07 21 All rights reserved ALTRONIC LLC 2021 88 FIGURE 7 MAGNET ASSEMBLY...
Page 89: ...CPU XL VariSpark IOM 07 21 All rights reserved ALTRONIC LLC 2021 89 FIGURE 8 MAGNET ASSEMBLY...
Page 90: ...CPU XL VariSpark IOM 07 21 All rights reserved ALTRONIC LLC 2021 90 FIGURE 9 MAGNET ASSEMBLY...
