Alpine CVA-1006R, Owner'S Manual

Page: 11 / 70

9
-EN
Lowering the Monitor
1
Press the OPEN/CLOSE button.
The unit will beep 3 times and lower the monitor
automatically.
NOTES
•
The IVX-C806/IVX-M706/CVA-1006R is a precision
device. With gentle handling, its unique capabilities
can be enjoyed for a long time.
•
If the monitor touches an obstacle while it is being
lowered, the unit will stop lowering the monitor
immediately.
Should this occur, remove the obstacle and press the
OPEN/CLOSE button again to lower the monitor.
Turning Power On or Off
1
Press the PWR (Power) button to turn on the
unit.
The opening screen appears automatically.
NOTE
The unit can be turned on by pressing any button on the
unit except the MUTE, OPEN/CLOSE and
(ANGLE) buttons.
2
Press the PWR (Power) button again to turn off
the unit.
NOTES
•
Some of this unit's functions, cannot be performed
while the vehicle is in motion. Be sure to stop your
vehicle in a safe location and apply the parking brake,
before attempting these operations.
•
The IVX-C806/IVX-M706/CVA-1006R draws minimal
current even when its power switch is turned off. If the
switched power (ignition) lead of the IVX-C806/IVX-
M706/CVA-1006R is connected directly to the positive
(+) post of the vehicle's battery, the battery may be
discharged. If this lead is unswitched, it must be
disconnected from the battery post should the vehicle
be left unused for an extended period of time.
An SPST (Single-Pole, Single-Throw) switch (sold
separately) can be added to simplify this procedure.
Then, you can simply place it in the OFF position
when you leave the vehicle. Turn the SPST switch back
ON before using the IVX-C806/IVX-M706/CVA-
1006R. For connecting the SPST switch, refer to
"Connection Diagram of SPST switch" on page 63.
•
Some operation of the unit cannot be performed while
the vehicle is in motion. In this case, be sure to first
stop your vehicle and apply the parking brake, then
perform the operation.
Selecting the Monitor Opening
Angle
The monitor opening angle can be set in 2
positions.
1
Press and hold the OPEN/CLOSE button for at
least 2 seconds while the monitor is being
raised. Each press changes the monitor angle
back or forth.
Adjusting the Monitor Viewing
Angle
Adjust the monitor's angle for better visibility.
1
Press the and buttons to adjust the
monitor's angle so the screen will be in the best
viewing position. Each press of the buttons
produces a beep and changes the screen angle
between 80 and 104 degrees.
NOTES
•
If the monitor touches an obstacle while the angle is
being adjusted the unit will stop the screen
immediately.
Should this happen, remove the obstacle and press the
or button again.
•
The screen colour will vary when viewed at certain
angles. Adjust the screen angle for the best viewing
position.
•
If the voltage of the vehicle's battery power is low, the
screen may blink when the screen angle is changed.
This is normal and not a malfunction.