Chapter 5 Detailed Function Introductions
112
Setting
Function
Setting
Function
62
Reserved
63
Reserved
64
Reserved
65
Reserved
66
Reserved
67
Reserved
68
Reserved
69
Reserved
70
Reserved
71
Reserved
72
Reserved
73
Reserved
74
Reserved
75
Anti rotor-blocking command (reserve)
76
Zero servo command(reserve)
77
PID output is forced to 0
78
PID integral time reset
79
Command channel switch to Keypad
control
80
PUL: Pulse input
81
Single phase speed measurement pulse or
double phase speed measurement A phase
pulse input
82
Double phase speed measurement B
phase pulse input
Notes to functions listed in Table 5-3-1:
0: NULL: No defined
The defined terminal is invalid. The inverter does not detect the status of the terminal nor response to the
terminal. In other words, the function of terminal is forbidden. To avoid disturbance or mistake action
effectively, define the terminals that are not in use as this function
1~ 5: Operation mode
See P3.15 operation mode setting
6: RST: Reset
In fault state, the inverter can be reset by keypad by pressing “STOP/RESET ” or by terminal on or off, if the
terminal has been set as RST function. In running state, it can stop the inverter according to selection of stop
mode. RST function is active at the rising edge, so it must be operated as “disabled-enabled-disabled”, shown
in Figure. 5-3-1.
Figure. 5-3-1 Terminal reset
