Allen-Bradley 22-COMM-E FRN 1.xxx, User Manual

Page: 20 / 166

2-2 Installing the Adapter
1. Set the Operating Mode Switch (SW1) for Single or Multi-Drive
operation (see
Figure 2.1 and setting descriptions below). For
complete details on Multi-Drive mode operation, see Chapter 7 ,
Using Multi-Drive Mode .
Figure 2.1 Setting Single/Multi-Drive Operation and Web Page Enable Switches
2. Set the Web Pages Switch (SW2) to enable or disable the adapter web
pages (see
Figure 2.1 and setting descriptions below). By default, the
adapter web pages are disabled. For complete details on the adapter
web pages, see
Chapter 9 , Viewing the Adapter’s Web Pages .
!
ATTENTION: Risk of equipment damage exists. The EtherNet/IP
adapter contains ESD (Electrostatic Discharge) sensitive parts that can
be damaged if you do not follow ESD control procedures. Static control
precautions are required when handling the adapter. If you are
unfamiliar with static control procedures, refer to
Guarding Against
Electrostatic Damage , Publication 8000-4.5.2.
SW1 Setting Description
Down position
(DN = Closed = 0) Sets the adapter for Single drive mode (default setting) using a
single drive connection.
Important: In this mode, connections to multiple drives must be
removed since all powered and connected hosts will respond to
any message sent by the adapter.
Up position
(UP = Open = 1) Sets the adapter for Multi-Drive operation mode using up to 5
different drives. DSI peripherals (22-HIM-*, 22-SCM-*, etc.) do
not operate with the adapter in this mode.
SW2 Setting Description
Down position
(DN = Closed = 0) Disables the adapter web pages (default setting).
Up position
(UP = Open = 1) Enables the adapter web pages.
2
1
OPERATING
MODE SWITCH
Single-Drive
Operation
Position
Multi-Drive
Operation
Position
Disable Web
Position
Enable Web
Position
WEB PAGES
SWITCH