Allegion Schlage D Series, Manual

Page: 532 / 573

Latches
Schlage • AL-Series service manual • 31
Latches
Part number Backset Housing
diameter
Description
Springlatch Deadlatch
11-068 11-085
2 C\, " M\, "
Square corner, 1" x 2
Z\v
"
11-069 11-088
Z\v " radius round corner, 1" x 2
Z\v
"
11-110 11-104 1" 1" circular drive-in, (605 and 626 finish only)
11-111 11-091
2 C\v " M\, "
Square corner, 1" x 2
Z\v
"
11-112 11-092
Z\v " radius round corner, 1" x 2
Z\v
"
11-116 11-096 1" Square corner, 1
Z\,
" x 2
Z\v
", standard
11-113 11-105 1" circular drive-in, (605 and 626 finish only)
11-118 11-103
3 C\v "
1" Square corner, 1
Z\,
" x 2
Z\v
"
11-116 11-096 11-104
Î
Note: 2 C\, ” backset latches
require backset extension
link 41-005. See “Latch
Accessories and Adapters”
below.
Î
Specify latch finish: 605,
606, 609, 612, 613, 619,
625, 626, 643.
Latch accessories and adapters
Part number Description
37-001 Metal door reinforcement kit for
M\,
” and 1” diameter housings. (Specify door thickness)
39-030 *
Adapts a square corner latch and a 2 C\v ” high square corner strike to a
Z\x
” rabbeted door and frame preparation
41-005 ** 5” Backset extension link (must be used with 2
Z\,
” backset latches)
A501-565 Reinforcement for non-reinforced metal doors 1
C\,
” thick. Fits both
M\,
” and 1” diameter housings
A501-566 Reinforcement for non-reinforced metal doors 1
C\v
” thick. Fits both
M\,
” and 1” diameter housings
A501-567 3
Z\x
” long latch housing sleeve, reinforcement for joint between latch and backset link, or to hold latch in metal doors
A501-878 Faceplate adapter to adapt 1” faceplate to 1
Z\,
” door preparation
G506-815 1” long latch housing sleeve to adapt
M\,
” diameter housing to 1” latch bore
37-001 41-005 G506-815 39-030
Sleeve, A501-567
Reinforcement
A501-566, 1
C\,
” door
A501-567, 1
C\v
” door
Spacer for latch
Shield for strike
* 39-030 Rabbeted latch and strike kit is available for Springlatch and Deadlatch applications. Available in 605 and 626 finish only.
** 41-005 requires: 1) reinforcement when used in hollow metal doors, and 2) one G506-815 sleeve when used with 1” latch holes.