Allegion Schlage D Series, Manual

Page: 491 / 573

222 • Schlage • L-Series service manual
L400-Series 180 degree indicator installation instructions
L400-Series 180 degree indicator installation
instructions
Indicator trim is available for either the inside or outside of the door on allowable functions.
Non-indicator trim is furnished on the opposite side of the door.
The L400 lock with indicator is not intended for exterior door applications.
For retrofit, see page 6.
Check the door preparation dimensions with the template included in the package.
Tools
Non-indicator options
Cylinder turn
L463 only
Indicator options
Cylinder
Cylinder
Thumb turn
Thumb turn
L400 Series Lock with Indicator Sectional Trim
Installation Instructions
L400 Lock with Indicator
1
Prepare the door for indicator trim
Two
Z\,
" pilot holes are required to mount the indicator.
ONLY ONE SIDE OF THE DOOR – THE INDICATOR SIDE –
REQUIRES THIS PREPARATION. Use the template included in
the package to mark the location of the pilot holes before drilling.
Inside of door Outside of door
¹⁄₈
" pilot
hole x 2
¹⁄₈
" pilot
hole x 2
For cylinder
if applicable
For cylinder
if applicable
For outside
indicator
only
For inside
indicator
or thumb turn
2
Install lock chassis
Note:
Pilot holes for
INDICATOR
ONLY
DO NOT FULLY TIGHTEN
CHASSIS MOUNTING SCREWS.