Installing the PS-I185AC-P (SDR-240-55) Power Supply
OmniSwitch 6855 Series Chassis and Hardware Components
page 2-48
OmniSwitch 6855 Series Hardware Users Guide
September 2011
DC Output Power Cord
Warning.
Do not insert the NEMA 5-15 plug or IEC 60320 C15 power connector into the system power
supply or any live power source until prompted to do so. Failure to follow these instructions may result in
bodily injury and/or equipment damage.
Before installing the PoE power supply in the chassis power supply tray, be sure to properly install these
power cords by following the steps below.
1
To install the output power cord, begin by inserting the BLACK wire into either of the V- terminals
located at the top-front of the PoE power supply.
2
Next, insert the WHITE wire into either of the V+ terminals.
3
Using a screwdriver torque each terminal to 7 inch-pounds.
4
Secure the remaining ground wire to the power supply using the supplied attachment screw. Insert the
screw through the ground wire connector and tighten firmly.
Output Power Terminal Locations
Top-Front of Power Supply
V+
V-
