Table-Mounting OS6855-14/P14 and OS6855-U10 Switches Mounting OS6855-14/P14 and OS6855-U10 Switches
page 4-24
OmniSwitch 6855 Series Hardware Users Guide
September 2011
Note.
For switches using redundant chassis power with PoE, place the power supplies connected to the
PS1 and PoE1 ports side-by-side in the tray. The power supplies connected to ports PS2 and PoE2 will be
placed in an additional power supply tray later in the installation.
6
Position the power supply retaining strap over the power supplies. Insert the retaining strap’s tabs into
the notches located on the left and right sides of each power supply in order to hold each power supply
firmly in place. Be sure that the tabs are completely inserted in the power supply notches and that the end
flanges of the retaining strap fit
inside
the walls of the power supply tray.
7
Secure the retaining strap to the power supply tray using the attachment screws (provided).
8
Plug the power supply cord into the female AC connector located on the back of each power supply
brick.
Note.
For PoE configurations, the system power supplies will already have power cords plugged into the
AC connectors. Plug the power supply cord into the female AC connector in each PoE power supply, as
applicable.
Note.
Use only the power cord(s) supplied with your OmniSwitch. The power supply’s female AC
connector includes a small notch that restricts the installation of many standard, non-OS6855 AC power
cords. Never force the power cord into the female AC connector.
9
Install one cord retainer bracket to the back of each installed power supply using the attachment screws
(provided). Once all retainer clips are attached, place the slotted retainer clip over the bracket with the
Retaining strap tabs
Power supply brick
Power supply tray
Notches in power supply
Attachment screw
