Reloading Switches
Managing OmniSwitch 6855 Series Stacks
page 7-30
OmniSwitch 6855 Series Hardware Users Guide
September 2011
If there are only two switches in the stack, the switch that was reloaded (the former secondary) resumes
the secondary role when it comes back up.
Reloading the Secondary Management Module In a Stack of Two
In this stack of two OmniSwitches, the slot 1 switch is the primary
management module. The slot 2 switch is the secondary.
The user reloads the stack’s secondary management module by
issuing the
reload secondary
command. Any data flow on the
secondary switch’s Ethernet is interrupted.
As the secondary switch reboots, the primary management mod-
ule continues to operate without interruption. Meanwhile the
stack has no interim secondary management module as the switch
reboots.
1
2
3
-> reload secondary
Primary - Slot 1
Secondary - Slot 2
When the rebooted switch comes back up, it assumes the secondary
management role within the stack.
4
Primary - Slot 1
Booting...
Primary - Slot 1
Secondary - Slot 2