Table-Mounting OS6855-14/P14 and OS6855-U10 Switches Mounting OS6855-14/P14 and OS6855-U10 Switches
page 4-20
OmniSwitch 6855 Series Hardware Users Guide
September 2011
Table-Mounting OS6855-14/P14 and OS6855-
U10 Switches
General Table-Mounting Guidelines
OmniSwitch 6855 Series switches can be installed freestanding as tabletop-mounted units. If you will be
table-mounting your switch(es), refer to the important guidelines below before installing.
•
When choosing a location for the switch, be sure that adequate clearance has been provided for chassis
air flow and access to the front, back, and sides of the chassis. For recommended clearances, refer to
“Recommended Clearances” on page 4-3
.
•
The power cord for OmniSwitch 6855 switches measures two (2) meters (approximately 6.5 feet) in
length. When table mounting the switch, be sure that the mounting location is within the reach of all
the required power sources.
•
A table-mount kit containing additional brackets is required (Kit No. OS6855-MNT).
Positioning the Power Supply Tray(s)
When table-mounting the switch, the power supply tray may be positioned either at the left side of the
chassis or directly behind the chassis.
This section will detail steps for installing the power supply tray directly behind the OS6855 chassis. For
instructions on installing the power supply tray at the left side of the chassis, refer to steps 1 through 17,
beginning on
page 4-5
. When complete, return to this section for additional table-mounting steps.
Installation
1
To install the switch as a tabletop unit, begin by removing the S-bracket located at the left-rear portion
of the switch chassis. Once removed, set the bracket and attachment screws aside and store in a safe place
in case another mounting configuration is preferred at a later date.
Remove the side S-bracket from the chassis
by removing the two chassis attachment
screws.