AL-KO BKS 35/35, Manual

Page: 19 / 238

GB 6
How to avoid it:
1. Empty the oil for saw chains out of the oil tank of the
chain saw.
2. Replenish the tank with little engine oil.
3. Allow the chain saw run for some time to enable the
oil leadings and oil pump clean.
Before other use of the chain saw, replenish the tank with
oil for saw chains again.
4 Putting the Saw into Operation
4.1 Engine Start
Before starting the saw be sure to loosen the
chain brake. The safety cover should be pulled
to the front handle..
A = RUN
Positions of choke button B = HALF – warm start
C = CHOKE – cold start
4.1.1 Cold Start
1.
Set red stop switch to "I”.
2. Move the CHOKE lever to cold start .
3. Push the primer bulb (11/1) 10 times, once in ca
2 seconds.
4. Depress the latch (12/1) and hold it depressed.
5. Depress the throttle trigger (12/2) and hold it de-
pressed.
6. Now depress the latch (12/1) completely down.
7. Release the throttle trigger (12/2) and then the latch
(12/1). The throttle trigger and the latch are blocked
now.
8. Assume safe and firm position and put the chain
saw onto the ground so that the guide bar is not lim-
ited by anything.
9. Put you right tiptoe to the rear handle.
10. Pull starter rapidly 4 times. Beware of moving chain.