25
With the aid of this menu a controlling program of an arbitrary language may be
created. This is the place where it is possible to change or edit the words and expressions that
are used in the existing controlling program.
The following functional options listed below are available:
4.4.9.1.
Source language
(D.9.1.)
It is possible to select here from the roll-down list the source language that serving as
the basis of the new language to be created. There are three different languages (English,
Russian and Hungarian) asfactory defaults.
After selecting the appropriate source language the words belonging to the given
language are displayed in table (
D.9.3
.).
4.4.9.2.
Destination language
(D.9.2.)
It is possible to select from the roll-down list either the new language which is to be
created or a language already existing. In case a non existing language, that is a language to
be created is selected, then the word-list table marked
(D.9.4.)
is left blank, but only if in the
dialogue window opened no language to be cloned had been selected. If in the dialogue
window an already existing language is selected, then table
(D.9.4.)
will contain the word-list
of the language selected for cloning.
4.4.9.3.
Caption
(D.9.5.)
After selecting a line in tables (
D.9.3.
and
D.9.4.
) the word included in table
(D.9.4.)
appears in the blank field that is located below it
«Caption» (D.9.5.)
as well, where it is
possible to modify it or it is possible to enter the meaning of the given word in an other
language. This field is left blank, if nothing is written in the line that is selected in table
(D.9.4.)
, however, even in this case, it is possible to enter an arbitrary word.
4.4.9.4.
Replace (D.9.6.)
For recording the modification or the new word that is entered into the blank field
located under
«Caption» (D.9.5.)
button
«Replace» (D.9.6.)
has to be pressed, which at the
same time records the new version into table
(D.9.4.)
as well.
4.4.9.5.
Save and Exit
(D.9.7.)
For saving the changes that have been made in the tables press the button
«Save and
Exit» (D.9.7.)
Before a new language to be cloned is selected in field
(D.9.2.)
a dialogue window
opens asking confirmation for saving the changes that have been made previously. This
window appears only if previously changes have been made.
Summary of Contents for CS5 CONFERCONTROL
Page 54: ...54 ...