AKG CS5 CONFERCONTROL, Manual, Page: 23 / 54

23
Diagram 13: «Chip card» window (D.8.)
The following functional options are available:
4.4.8.1. Table of Chipcards (D.8.1.)
The address of those units can be seen here into which a chip card has been inserted and
were connected to the system. The left side column of the table contains the unit addresses of
the delegate units, while the right side column shows the identification number of the
chipcard inserted into the given unit.
When the chipcard is pulled out from the unit the line containing the address of the
given unit and the identification number of the card pulled out is deleted. When a chipcard is
inserted a new line appears in the table, in which the address of the given unit and the
identification number of the inserted card can be seen.
4.4.8.2. Chipcard number (D.8.2.)
After selecting a line from table (D.8.1.) in the field of «Card number» (D.8.2.) the
identification number of the card included in the selected line is displayed. Buttons «Read»
(D.8.3.) and «Write» (D.8.4.) are activated simultaneously.
4.4.8.3. Reading and writing a chipcard (D.8.3. and D.8.4.)
With the aid of press button «Read» (D.8.3.) it is possible to read the identification
number of the card inserted into the card reader of the unit selected from the table (D.8.1.) .
For changing the identification number of the card the appropriate number has to be entered
with the keyboard into the
«Card number» (D.8.2.) field, then button «Write» (D.8.4.) has to
be pressed. At this point the old card number is deleted and the new number is recorded, and
it is simultaneously displayed in the table
(D.8.1.) .
D.8.5.
D.8.2.
D.8.4.
D.8.1. D.8.3.