288
Q-Link Knobs
These are the MIDI parameters you can edit for each
Q-Link knob
:
Control
: This is the hardware control you are currently editing (
QLink 1
–
4
).
Light LED
: Although you can edit this parameter, it does not actually have a function on your MPC hardware.
When set to
Never
, the LEDs will always be off.
When set to
MIDI Input
, the LEDs will light up when the software receives a MIDI message that matches the
Q-Link knob.
When set to
Local
, the LEDs will light up when you touch or turn the Q-Link knob and/or MIDI input is received.
MIDI Channel
: This determines which MIDI channel (
1
–
16
) the Q-Link knob will use to send its message to the
software.
CC Number
: This determines what MIDI Control Change number the Q-Link knob will send to the software.
Mode
: This determines how the Q-Link knob will control its parameter.
Absolute
: The Q-Link knob’s current position determines its parameter’s value; moving it may cause its
parameter to “snap” to a new position if you’re using it to control different parameters in different modes.
Relative
: Moving the Q-Link knob will increase or decrease its parameter regardless of its physical position.
Low Range
: This is the Q-Link knob’s lowest possible value (
0
–
127
).
High Range
: This is the Q-Link knob’s highest possible value (
0
–
127
).
Touch Sense
: This activates or deactivates the Q-Link knob’s touch-capacitive circuitry.
On
: You can touch the Q-Link knob to send a Note On message to the software (this is how your MPC
hardware normally works).
Off
: The Q-Link knob will not send any Note On messages; it will only send CC messages when you turn it.
Note
: This is the MIDI note number the Q-Link knob will send to the software when you touch it (
0
–
127
or
C-2
to
G8
).
Touch Sense
must be set to
On
for this to work.
Summary of Contents for MPC Touch
Page 1: ...User Guide English Manual Version 2 0 8...
Page 322: ......
