207
The
green
/
S
marker and
red
/
E
marker are the start point and end point (respectively). These two points define the
region of the sample that will be played.
To move the start point or end point
, do any of the following:
•
Tap and drag the
S
or
E
marker left or right.
•
Use the
Start
or
End
fields shown below the waveform.
•
Use the
first
column of
Q-Link knobs
to adjust the start point or the
second
column of
Q-Link knobs
to
adjust the end point. The top-most Q-Link knob provides coarse adjustment. The bottom-most Q-Link knob
provides fine adjustment.
Note
:
When
Loop Lock
is on, the loop position (as determined by the
Loop
field, if enabled) is the same as the
sample’s start point. When off, the loop position is independent from the start point.
Use the
Loop
field
to determine the position where the sample’s playback will repeat when
Pad Loop
is activated.
Alternatively, use the
third
column of
Q-Link knobs
to adjust the loop point. The top-most Q-Link knob provides
coarse adjustment. The bottom-most Q-Link knob provides fine adjustment.
Note
:
When
Loop Lock
is on, the loop position is the same as the sample’s start point. When off, the loop position is
independent from the start point.
Use the
Slice
field to select what part/parts of the sample will play:
All
: The entire sample will play.
Pad
: The sample will play from the
Pad Start
position to the
Pad End
position, described
earlier
. This also lets
you activate
Pad Loop
(if the
Sample Play
field in the
Master
tab is set to
Note On
).
Slice 1, 2, 3, etc.
: If you have sliced the sample in Chop Mode, you can select which slice will play when you
trigger the pad.
Semi
lets you transpose the selected layer 36 up to semitones up or down. This is the same as the
Semi
knob on the
second
Samples
tab.
Fine
provides fine-tuning of each layer by cents. This is the same as the
Fine
knob on the second
Samples
tab.
Summary of Contents for MPC Touch
Page 1: ...User Guide English Manual Version 2 0 8...
Page 322: ......
