Akai MPC Touch, User Manual

Page: 281 / 322

281
Pad Parameter
In the
Pad Parameter Q-Link Edit Mode, the Q-Link knobs control the same pad parameter for the each of the 16
pads in the current pad bank.
For example, if the
Parameter is set to Level , the 16 Q-Link knobs will adjust the 16 independent Level settings for
each pad in the current pad bank. You could then set the Parameter to Pan and use the Q-Link knobs to adjust the
panning of all 16 pads.
Next to the top row of Q-Link knobs on the screen, tap one of these tabs to select the type of parameter you want to
control with the Q-Link knobs:
Mixer : general mixer parameters
Program : pad parameters (i.e., parameters used in Program Edit Mode)
Use the
Parameter field to select the parameter you want to control with the Q-Link knobs.
Mixer : Off, Level, Pan, Pad Mute, Pad Solo, Send 1–4
Program :
Off Amp Env Hold Layer Sample Pan (1–4) LFO to Filter Velocity to Amp
Tuning Amp Env Sustain Layer Semi Tune (1–4) LFO to Amp Velocity to Pan
Filter Cutoff Filter Env Attack Layer Fine Tune (1–4) LFO to Pan Layer Direction (1–4)
Filter Resonance Filter Env Hold Velocity to Start LFO Wave Layer Offset (1–4)
Filter Env Amount Filter Env Decay Vel to Filter Attack LFO Rate
Amp Env Attack Filter Env Sustain Velocity to Env Amount LFO Sync
Amp Env Decay Filter Env Release Velocity to Filter Velocity to Pitch
Amp Env Release Layer Level (1–4) LFO to Pitch Vel to Volume Attack
Tap the
Momentary checkbox to turn momentary behavior on or off.
When on , moving the Q-Link knob will adjust its parameter, but the parameter will immediately return to its
original position (when you turned Momentary on) when you release the Q-Link knob.
When
off
, moving the Q-Link knob will adjust its parameter, and the parameter will remain at its new setting
when you release the Q-Link knob.