FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1 48 www.aja.com
• View the FS-HDR SDI output signal on a compatible HDR display.
Procedure
System Configuration
1. If the FS-HDR is not already in Four Channel Mode, press the
CONFIG
System
button:
• Select
2 FS-HDR Mode
, select
HD/SD
and press the ADJUST knob. Wait for the
FS-HDR to reboot (not longer than 90 seconds).
2. Press the
VIDEO
System button.
• Select
1 Output Frame Rate
, and adjust to
59/29/23
.
• Select
2 Genlock Source
, and adjust to
Reference
.
Video Processor 1 Setup
3. Press the
VID1
Channel Select button
4. Press the
INPUT
Video button
• Select
1 Input
, and adjust to
SDI1
.
• Select
2.1 Dynamic Range&Gamut
, and select
SDR BT.709 100 Nits
.
5. Press the
FORMAT
Video button.
• Select
1 Output Format
, and adjust to
1080p5994
.
• Select
2.1 Dynamic Range&Gamut
, and select H
ybrid Log Gamma BT.2100.
6. Press the
INPUT
Video button
• Select
2.2 SDR Highlights
and select for best image from: Standard (default),
Soft 1-3, or Bright.
NOTE: The SDR Highlights parameter is only active when transforming from SDR to
HDR. Source SDR video dynamic range compression can vary, and only be visible
when expanded to HDR. This parameter offers five different presets that can be
used to try to match the source material. For lesser quality SDR video that exhibits
substantial clipping, a less aggressive expansion is a better choice. The Soft 1 to 3
settings are progressively less aggressive.
7. If you have optional SFP output modules installed, you can select
FORMAT
3.0 Link Cfg SDI5
and adjust to
Sngl Lnk LvlA
for an additional copy of that
converted signal.
Video Processor 2, 3, and 4 Setup
8. Press the
VID2, 3 or 4
Channel Select button.
9. Repeat the Video Processor 1 setup steps described above, substituting 2/6,
3/7, and 4/8 as appropriate.
The video switcher should now be able to accept all the converted to HLG signals.
Multiple Simultaneous HDR and SDR Distribution
The following workflow demonstrates simultaneously distributing HDR and SDR
content. In this example, the FS-HDR converts one HDR input to a different HDR
format output and also converts it to an SDR output. Simultaneously the FS-HDR
also converts two other signals, one from a BNC input, and the other from an SFP
module input. Four Channel mode operation is required.
