FS-HDR Frame Synchronizer/Converter/HDR-WCG Processor v1.0r1 45 www.aja.com
Figure 24. Single Channel Mode, Down and HDR Cross-Conversion
SDI In 1 BNC
(w Embedded Audio)
SDI In 2 BNC
(w Embedded Audio)
SDI In 3 BNC
(w Embedded Audio)
SDI In 4 BNC
(w Embedded Audio)
SDI In 5 SFP
SDI In 6 SFP
SDI In 7 SFP
SDI In 8 SFP
SDI Out 5 SFP
(w Embedded Audio)
SDI Out 6 SFP
(w Embedded Audio)
SDI Out 1 BNC
(w Embedded Audio)
SDI Out 2 BNC
(w Embedded Audio)
SDI Out 3 BNC
(w Embedded Audio)
SDI Out 4 BNC
(w Embedded Audio)
SDI Out 7 SFP
(w Embedded Audio)
SDI Out 8 SFP
(w Embedded Audio)
Quad Link 4K
4096x2160p
59.94 PQ
Down Convert to
1920 x1080p 59.94 HLG
Down Convert to
1920 x1080p 59.94 HLG
Down Convert to
1920 x1080p 59.94 HLG
Down Convert to
1920 x1080p 59.94 HLG
Down Convert to
1920 x1080p 59.94 HLG
Down Convert to
1920 x1080p 59.94 HLG
Down Convert to
1920 x1080p 59.94 HLG
Down Convert to
1920 x1080p 59.94 HLG
Eight copies of
the same signal
on all outputs
Outputs 5-8
require optional
SFP modules
4K Down-Conversion and HDR Cross-Conversion
Single Channel Mode
Incoming embedded
audio is disembedded,
sent to the Audio Processor,
and can be routed
to the output.
4K/UHD
Video Processor with
Colorfront Engine
Table 3. Menu Settings for Single Channel Mode, Down and Cross Conversion
Channel Select Button Video Button Menu Name
Setting
VID1
INPUT
1 Input
1-4 QuadLink
VID1
INPUT
2.1 Dynamic Range&Gamut
PQ BT.2020 1000Nits
VID1
FORMAT
1 Output Format
1080p5994
VID1
FORMAT
2.1 Dynamic Range&Gamut
Hybrid Log Gamma BT.2100
VID1
FORMAT
3.0 Link Cfg SDI1-4
Sngl Link LvlA
VID1
FORMAT
4.0 Link Cfg SDI5-8
Sngl Link LvlA
Setup
• Ensure the FS-HDR is receiving a valid reference signal. Connect a 1080p 59.94
HD tri-level sync signal to one of the Ref Loop BNC connectors, and terminate
the other Ref Loop BNC connector.
• Connect a Quad Link 4K 59.94 signal to the FS-HDR SDI 1, 2, 3, and 4 video
input BNC connectors.
• Connect any one of the FS-HDR SDI BNC output connectors to a compatible
HDR video monitor.
• Ensure the FS-HDR Vid (n) FORMAT
2.2 Dynamic Range Clamp
parameter is set
to
No Clamp
(default).
Procedure
System Configuration
1. If the FS-HDR is not already in Single Channel Mode, press the
CONFIG
System button:
• Select
2 FS-HDR Mode
, select
4K/UHD
and press the ADJUST knob. Wait for
the FS-HDR to reboot (not longer than 90 seconds).