Scholar V Installation & Startup Manual 07/2016 New
30
1.14 REMOTE TEMPERATURE/RH TRANSMITTER LOCATION (OPTIONAL)
Locate the thermostat about five feet above the floor on an inside wall. Avoid the
following:
Hot Spots
Cold Spots
Dead Spots
Concealed Pipes/Ducts Concealed Pipe/Ducts
Behind Doors
Registers
Stairwells - Drafts
Corners and Alcoves
TV Sets
Doors - Drafts
Radios
Unheated Rooms on Other Side of Wall
Lamps
Direct Sunlight
The thermostat should be wired to the terminal strip in the Scholar V heat pump or air
conditioner in accordance with the following diagram, and in accordance with National
Electric Code, and with local electrical codes, where they may prevail. Since the
transmitters send analog signals, it is best to use shielded wire no smaller than 20
gauge.
The temperature transmitter and the relative humidity transmitter are on separate
boards in a single housing.
Figure 15. Temperature/Relative Humidity Connection
