Compliance
AGD155 Product Manual Rev.2.2
Page 12
Warning
Capacitors on the DC bus can retain hazardous voltages after input power has been
removed. Discharge time to below 60 VDC is 10 minutes.
Wait until the red LED (Charge indicator) shuts off before physically touching the
product. The product must not be opened or serviced until the discharge is complete.
Failure to observe this precaution could result in severe bodily injury or loss of life.
Attention
Do not attempt to hinder or override the product’s or system’s fault detection or
protection circuits. You must determine the cause of a fault and correct it before you
attempt to operate the system. Failure to correct the fault could result in personal
injury and/or damage to equipment.
2.3 Compliance
Standards Compliance
Description
Standard
Safety requirements – Electrical, thermal and energy
IEC-61800-5-1
EMC requirements and specific test methods
IEC-61800-3
This product is intended to operate in a machine or equivalent end-product. The machine or end-
product must comply with any necessary safety standard as typically required for the same type of
machine or end-product. It is the responsibility of the machine or end-product manufacturer to
ensure the final machine or end-product meets the requirement of any safety and EMC regulations.
