Agilent G3437A Side-Mounted Thermal Conductivity Detector
Installation Instructions
17
3
Attach the filament leads (thick black wire sheath) and the
Δ
PRT leads
(thin white wire sheath) from the TCD to the TCD board as the
configuration shown in
Figure 22
. Using a small flat-blade screwdriver to
push on the connector tabs, firmly push away from the connector hole,
insert the appropriate lead into the connector hole, and release the tab to
complete the connection.
Figure 22
TCD connected to TCD board
Route the communication bus cable
1
Connect the plug on the communication cable labeled Aux DET2 to the plug
labeled AuxDET2 in the EPC module area.
2
Connect the plug on the communication cable labeled EPC5 to the plug
labeled EPC5 in the EPC module area.
Figure 23
Communication bus cable connections
Orange connector tabs
EPC5 connection
Aux DET 2 connection
