10
Installation Instructions
Agilent G3437A Side-Mounted Thermal Conductivity Detector
8
Secure the fitting by attaching and tightening the backing nut.
Figure 12
Bulkhead fitting installed in frame
Prepare the detector mounting
1
Locate the position on the side of the GC for the detector. Remove the round
metal cutout at this location using diagonal cutters. Make the cuts so that
the metal nubs remain attached to the discarded metal circle.
2
Remove and discard the circular insulation plug.
3
Using the flat screwdriver, punch a hole (approximately ¼-in ID) in the
oven insulation.
Figure 13
Metal cutout removed and hole punched in oven insulation
Bulkhead fitting (without
ferrule)
Screw for bulkhead retainer
