Agilent Technologies E4418B, User Manual

Page: 72 / 199

2 Power Meter Operation
48 E4418B Power Meter User’s Guide
You cannot delete any of the 20 sensor calibration tables. Each sensor
calibration table can contain a maximum of 80 frequency points each. If you
want a new sensor calibration table, you must edit an existing one.
To edit a table:
1
Select one using the and keys to scroll through the displayed
tables. When the table you want to edit is highlighted, press .
The “Edit Cal” screen is displayed as shown in Figure 2- 5 on page 47 .
In this screen, you can modify, add, and remove frequency and
calibration factors and also edit the table name. Use the
, ,
, and keys to move between the table name and its frequency
and calibration factors.
A frequency in the range of 0.001 MHz to 999.999 GHz can be entered.
A calibration factor in the range of 1% to 150% can be entered.
The following rules apply to naming sensor calibration tables:
• The name must consist of no more than 12 characters.
• All characters must be upper or lower case alphabetic characters or
numeric (0- 9) or an underscore (_).
• No other characters are allowed.
• No spaces are allowed in the name.
2 To edit the parameter you currently have selected, press . The
power meter displays the data in a pop- up window. Modify this data (see
below) as desired.
• Use or to modify the character on which the cursor is
currently positioned.
• Use or to move to other characters.
3 To confirm your choice, press the appropriate softkey.
4 To add a new sensor calibration table entry, press . You are prompted
for the frequency and calibration factor. The entry is sorted by frequency.
N O T E
Predefined sensor calibration factor table stored in power meter is not applicable for
Agilent N8480 Series power sensors with Option CFT. Therefore, users are required to
create a new sensor calibration table for the sensors when a sensor calibration table is
needed.
Edit Table
Change
Insert