Agilent Technologies E4418B, User Manual

Page: 173 / 199

Error Messages 4
User’s Guide 149
–123 Exponent too large
A numeric parameter was found whose exponent was larger than 32,000.
For example, SENS:COUN 1E34000 .
–124 Too many digits
A numeric parameter was found whose mantissa contained more than 255 digits, excluding
leading zeros.
–128 Numeric data not allowed
A numeric value was received within a command which does not accept a numeric value.
For example, MEM:CLE 24 .
–131 Invalid suffix
A suffix was incorrectly specified for a numeric parameter. You may have misspelled the suffix.
For example, SENS:FREQ 200KZ .
–134 Suffix too long
A suffix used contained more than 12 characters.
For example, SENS:FREQ 2MHZZZZZZZZZZZ .
–138 Suffix not allowed
A suffix was received following a numeric parameter which does not accept a suffix.
For example, INIT:CONT 0Hz .
–148 Character data not allowed
A discrete parameter was received but a character string or a numeric parameter was
expected. Check the list of parameters to verify that you have used a valid parameter type.
For example, MEM:CLE CUSTOM_1 .
–151 Invalid string data
An invalid string was received. Check to see if you have enclosed the character string in single
or double quotes.
For example, MEM:CLE “CUSTOM_1 .
–158 String data not allowed
A character string was received but is not allowed for the command. Check the list of
parameters to verify that you have used a valid parameter type.
For example, LIM:STAT ‘ON’ .
–161 Invalid block data
A block data element was expected but was invalid for some reason. For example,
*DDT #15FET . The 5 in the string indicates that 5 characters should follow, whereas in
this example there are only 3.
–168 Block data not allowed
A legal block data element was encountered but not allowed by the power meter at this point.
For example SYST:LANG #15FETC? .