Agilent Technologies E3631-90002, User Manual, Page: 51 / 166

Chapter 3 Front-Panel Operation
Remote Interface Configuration
50
To Set the GPIB Address
To configure the power supply for the GPIB interface, proceed as follows:
1 Turn on the remote configuration mode.
You will see the above message on the front-panel display if the power
supply has not been changed from the default setting. If “RS-232” appears,
choose “GPIB / 488” by turning the knob to the right.
2 Select the GPIB address.
The address is set to “05” when the power supply is shipped from the
factory. Notice that a different GPIB address may appear if the power
supply has been changed from the default setting.
3 Turn the knob to change the GPIB address.
The displayed address is changed when turning the knob to the right or left.
4 Save the change and turn off the I/O configuration mode.
The address is stored in
non-volatile
memory, and
does not
change when
power has been off or after a remote interface reset. The power supply
displays a message to show that the change is now in effect. If the GPIB address
is not changed, “NO CHANGE” will be displayed for one second.
N o t e To cancel the I/O configuration mode without any changes during the
GPIB address selection, press the “I/O Config” key until the “NO
CHANGE” message is displayed.
GPIB / 488
ADDR 05
CHANGE SAVED
I/O Config
I/O Config
I/O Config