Agilent Technologies Agilent 33500 Series, User Manual

Page: 21 / 278

20
Chapter 1 Quick Start
To Set the Output Frequency
1
To Set the Output Frequency
At power-on, the waveform is configured for a sine wave at 1 kHz with an
amplitude of 100 mV peak-to-peak (into a 50
 termination).
The following steps show you how to change the frequency to 1.2 MHz.
1 Press the button, followed by the
Frequency
softkey.
The displayed frequency is either the power-on value or the frequency
previously selected. When you change functions, the same frequency is
used if the present value is valid for the new function. To set the
waveform
period instead, press , then press the
Frequency
softkey
to toggle to the
Period
softkey (the current
Frequency
selection is
highlighted in the image below.).
2 Enter the magnitude of the desired frequency.
Using the numeric keypad, enter the value 1.2.