Agilent Technologies Agilent 33500 Series, User Manual

Page: 110 / 278

109
Chapter 3 Features and Functions
Output Configuration
3
• For a triggered burst , the Sync signal is a TTL “high” when the burst
begins. The Sync signal is a TTL “low” at the end of the specified
number of cycles (may not be the zero-crossing point if the waveform
has an associated start phase). For an
infinite count burst , the Sync
signal is the same as for a continuous waveform.
• For an externally-gated burst , the Sync signal follows the external
gate signal. However, the signal will not go to a TTL “low” until the
end of the last cycle (may not be the zero-crossing point if the
waveform has an associated start phase).
• Front-Panel Operation : Press and press the
Sync
softkey
again to toggle between
Off
and
On
. You can also press
Sync Setup
to
configure Sync.
• Remote Interface Operation :
OUTPut:SYNC {OFF|ON}
OUTPUT[1|2]:SYNC:MODE {CARRier|NORMal|MARKer}
OUTPUT[1|2]:SYNC:POLARITY {NORMAL|INVerted}
OUTPUT:SYNC:SOURCE {CH1|CH2}