Agilent Technologies 5973N, Hardware Installation

Page: 24 / 60

24 Hardware Installation
Installation
Installing the GC
Materials needed:
Column cutter (5181-8836)
Flat-blade screwdriver
Wrenches, 7/16 inch, open-ended (2 needed)
6890 Series GC shipping kit
Please refer to the GC/MS application note, Optimizing splitless
injections on your GC for high-performance MS analysis
(5988-9944EN) before installing the GC.
1
Place the GC on the bench.
2 Remove the left side panel of the GC.
3 Remove the metal upper front knockout from the interior
oven wall, using a flat-blade screwdriver (see
Figure 3 ).
4 Do not remove the insulation between the exterior and
interior oven walls, but move it aside. Use the screwdriver,
not your fingers.
5 Pop out the two large plastic knockouts from the GC left side
panel.
6 Reinstall the GC left side panel cover and route the GC end of
the GC/MSD interface heater cable through the lower hole.
WA R N I N G
To prevent injury, get lifting assistance.