Agilent Technologies 4395A, Manual Change

Page: 221 / 575

T o Save and Recall
T o Save and Recall the Settings and Data
This step provides the following procedures for saving and recalling:
T o save an analyzer setting or measurement data
T o recall a saved analyzer setting
T o save a display image to a TIFF le
T o save measured data for a spreadsheet
T o copy a le between oppy disk and memory disk
T o initialize a disk for use
T o initialize the memory disk for use
T o back up the memory disk
T o Save an Analyzer Setting or Measurement Data
The 4395A supports two storage devices , a built-in exible disk drive and a 512KB memory
disk. The exible disk drive should be used to store large numbers of les and for long term
data storage . Memory disk should be used for temporary data and instrument states and to
store or get data quickly .
Note
When you store important data into the memory disk, perform the memory
disk backup operation described in \T o Back Up the Memory Disk". Otherwise ,
the memory disk data is lost when the power is turned o.
1. Insert a LIF or DOS formatted 3.5 inch disk into the built-in disk drive (if you are recalling
an instrument state le from the memory disk, skip this step).
2. Press 4 Save 5 .
3. Select a save data type:
Save Data Type Press
Instrument states only
NNNNNNNNNNNNNNNNN
STATE
Measurement data only
1
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
DATA ONLY (binary)
1 Y ou can specify a data array type . See the \Specifying a Data Array Type "
procedure .
4.
Select where the le is stored by pressing either
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
STOR DEV [DISK] (for the built-in disk
drive) or
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
STOR DEV [MEMORY] (for the memory disk).
5.
Enter a lename . Then press
NNNNNNNNNNNNNN
DONE .
The analyzer automatically detects the disk format as either the LIF (Logical Interchange
F ormat) or DOS (Disk Operating System). If you insert an any other format type disk, an error
message is displayed.
F or more information, Appendix A provides a complete list of the instrument state to be saved.
Analyzing the Measurement Results 8-19