Agilent Technologies 4395A, Manual Change

Page: 183 / 575

7
Calibration
This chapter describes calibration procedures required for measurement in the network
analyzer mode and the impedance analyzer mode . F or details about calibration procedures , see
Appendix A.
In the spectrum analyzer mode , the 4395A requires no calibration procedure in the
measurement.
Note
When performing the 75 measurement in the spectrum analyzer mode , see
Chapter 2 to set the 4395A properly .
Calibration Required for the Network Analyzer Mode
This section provide procedures for performing calibration. The calibration eliminates the
errors and improves the measurement accuracy . The analyzer has six dierent methods of
calibration. Y ou can select the method that ts your measurement requirement by reading \T o
Select an Appropriate Calibration Method" procedure . This section also contains a procedure to
customize a calibration kit.
Selecting an appropriate calibration method
P erforming a response calibration
P erforming a response & isolation calibration
P erforming an S11 1-port calibration
P erforming an S22 1-port calibration
P erforming a full 2-port calibration
P erforming a 1-path 2-port calibration
Selecting the calibration kit
Customizing the user dened calibration kit
T o Select an Appropriate Calibration Method
The analyzer has six calibration methods . Y ou can choose the appropriate calibration method to
t your measurement by using T able 7-1.
Calibration 7-1