Agilent Technologies 34970A, User Manual, Page: 145 / 356

145
Chapter 4 Features and Functions
Alarm Limits
4
Using the Alarm Output Lines
Four TTL alarm outputs are available on the rear-panel Alarms
connector. You can use these hardware outputs to trigger external alarm
lights, sirens, or send a TTL pulse to your control system. You can assign
an alarm to any configured channel and multiple channels can be
assigned to the same alarm number. Each alarm output line represents
the logical “OR” of all channels assigned to that alarm number (an alarm
on any of the associated channels will pulse the line).
You can configure the behavior of the alarm output lines as described
below. The behavior of the alarm annunciators on the front panel also
tracks the alarm output configuration. The configuration that you select
is used for all four alarm output lines. A Factory Reset (
*RST
command)
clears all four alarm outputs but does not clear the alarm queue in either
configuration.
• Latch Mode : In this mode, the corresponding output line is latched
true when the first alarm occurs and remains asserted until you clear
it by initiating a new scan or cycling power. You can manually clear
the output lines at any time (even during a scan) and the alarm data
in memory is not cleared (however, data is cleared when you initiate a
new scan).
Alarms Connector
or
Alarm 4 Output
Alarm 3 Output
Alarm 2 Output
Alarm 1 Output
Gnd
34970A Refresh UG.book Page 145 Wednesday, February 17, 2010 12:34 PM