102
P1512115 R8
7. Fasten the bottom end of the muffler support bracket (10) to the engine adjustment plate with a 1/4" x 3/4"
carriage bolt (11) and 1/4" locknut (12).
8. Fill engine with oil up to the dipstick line.
Note
For a Kohler engine, the oil quantity required is approximately 1.8 L.
9. Refer to the Hydraulic Wet Kit section to install the hydraulic tank.
10. Route and install the hydraulic hoses (see “Assemble the Hydraulic Hose” in your wheel move manual for
guidelines on routing hydraulic hoses).
11. Install the hopper-side engine guard (6) using 3/8" x 1" bolts (7) and 3/8" locknuts (8) (see
12. Install the spout-side engine guard (9) using 3/8" x 1" bolts (7) and 3/8" locknuts (8).
Note
Orient the spout-side engine guard as shown in
so that the two factory-drilled holes in the
guard can be used in the position shown to install the fuel pump.
13. Attach a connector ring to each end of the fuel pump’s wiring.
14. Install the fuel pump (2) onto the spout-side engine guard using the factory-supplied bolts and flange nuts
(see
). Secure the black ground wire with the bottom bolt on the fuel pump.
Note
Make sure the flange nuts are on the side of the engine guard as shown so the serrations in the
flange nuts cut through the paint and into the metal of the engine guard to provide a good
connection for the ground wire.
15. Route and connect the red positive wire of the fuel pump into the engine wiring harness.
Note
The pump will engage when the ignition is turned on. The pump should turn off when the engine
turns off, otherwise you risk wearing out the battery.
Table 45.
Fuel Pump, Battery, and Engine Guards
Item
Description
Quantity
1
5/16" Nylon Locknut
2
2
Fuel Pump
1
3
5/16" x 1" Hex Bolt
2
4
Battery
1
5
Battery Box
1
6
Hopper — Side Engine Guard
1
7
3/8" x 1" Flange Bolt
12
8
3/8" Flange Locknut
12
9
Spout — Side Engine Guard
1
10
Muffler Support Bracket
1
11
1/4" x 3/4" Carriage Bolt
1
12
1/4" Nylon Locknut
1
PORTABLE GRAIN BELT CONVEYOR – FIELD LOADER
