P1512115 R8
99
Figure 76.
Installing the Pulleys and Belts
14. Install the clutch stop bracket (17) onto the engine with a 3/8" x 1-1/4" bolt (18) and 3/8" lock washer (19)
(see
15. Slide the soft start electric clutch (20) onto the engine shaft and clutch stop bracket (17). Align the clutch
pulley with the 12" pulley (5) using a straightedge. Tighten the clutch using a 7/16" x 3" fine-thread bolt (21)
and 7/16" lock washer (22).
Note
The soft start electric clutch comes with a factory pre-assembled 4" double pulley which is
assembled onto the engine shaft using the same 1/4" x 3-1/4" key (3) that was used to install the
hydraulic drive pulley (1).
16. Install two drive belts (23).
17. Set the tension of the drive belts (23) using the tap bolt (24) for the engine adjustment plate.
18. Set the tension of the hydraulic pump belt (4) by threading the pivot shaft (25) in or out of the nut of the
pump mount plate.
19. Install the clutch wiring module mount (26) using one 3/8" x 1" flange bolt (27) and locknut for the hopper-
side left mount arm.
20. Install the electric clutch wiring module (28) using two 1/4" x 1" Tek screws (29).
21. Install the wiring for soft start electric clutch (see
). Secure the ground wire to the motor mount
bolt.
4
1
13
16
3
2
6
14
15
25
6
5
6
4
1
13
16
3
2
6
14
15
25
6
5
6
10
12
9
8
7
11
10
PORTABLE GRAIN BELT CONVEYOR – FIELD LOADER
