Afag PDZ-128, Translation Of The Original Montage Instructions

Page: 55 / 58

PDZ-128-160-200 OI-vers. 3.2 gb. 03.07.2018 55
6.1.3 Stroke limitation
The stroke limit is used where the mechanical axis of the hub cannot be retracted. This may
arrive at the cross and vertical structures, for example, according to the pictorial
representation below.
As an end-position damping effect on each side two rubber buffer. The stroke limit is
understood as a purely emergency end-stop to damage to the axle and mounted parts (grab,
etc.) should be avoided! The movement is always stopped by the electric servo drives.
Types Order No.
Stroke limitation to PEZ-128 50403196 (1 Piece)
Stroke limitation to PDZ-160 50281047 (1 Piece)
Stroke limitation to PDZ-200 50281048 (1 Piece)
Set-Stroke limitation
Components have to be screwed up together in the image.
CAUTION
After driving from the axis slides are on the stroke limitation,
the stroke limit check for damage and replaced if damaged.
This ensures that the stroke limitation still operating properly.
6.1.4 Cover sensor nut (see technical catalog (Chapter 7)
Installation of the stroke limitation on the
axis.
Nuts to the desired position in the axis-profile
slots appeal.
Stroke limiting iron defer to the axis profile.
Screws with washers and spring washer use,
stroke limit position and tighten.