Afag PDZ-128, Translation Of The Original Montage Instructions

Page: 43 / 58

PDZ-128-160-200 OI-vers. 3.2 gb. 03.07.2018 43
3.2.8 Programming
WARNING
The gantry axis with attachments and superstructures should
be started up in set-up or jog mode. Incorrect programming can
trigger uncontrolled movements of the gantry axis. Fast or
unintentional movements of the module can result in personal
injury, even death, and damage to the unit.
Ensure that there are
no persons or loose tools within the Installation range of the gantry
axis.
The programming is different, depending on the controller used. Observe the
respective manuals of the controller provider.
If the Afag SE-Power control system is used, please observe the montage
Instructions which are supplied together with the control system.
You can also download this Montage Instructions from the Afag website:
www.afag.com
3.2.9 Hot surface on the motor
WARNING
The surface of the drive motor heats up (to 100°) during
continuous operation of the gantry axis! Caution is required so
that the system operator does not burn himself.
Precautionary measure: (wear protective gloves).