Afag PDZ-128, Translation Of The Original Montage Instructions

Page: 53 / 58

PDZ-128-160-200 OI-vers. 3.2 gb. 03.07.2018 53
6.0.0 Gantry axis superstructure
The axes can be installed as gantry units; further information about this can be found
in our handling catalogue or on the website.
6.1.0 Assembly process for Load transmission unit
Assembly Process:
1. Clamping set 1 (screws to the shaft pointing) and insert into the main shaft bearing
journals
2
,
A
(motor) and tighten.
2. Second Transmission shaft
7
with the couplings
3
and
4
prepare, (release clutch
3
and make flush with the transmission shaft 7 ).
CAUTION
High speeds with large loads occur for this application case;
therefore the necessary precautions must be taken with a safety
fence (protective device). The system constructor is
responsible for this! The company Afag Automation AG accepts
no responsibility for this!
Synchronous drive
Motor
Tap 2
Clamping set 1 Load transmission unit (Screw the shaft pointing)
Axle bearing A
Coupling 3
Transmission
Coupling 4 Tab 5
Clamping set 6
Axle bearing B