Afag PDZ-128, Translation Of The Original Montage Instructions

Page: 45 / 58

PDZ-128-160-200 OI-vers. 3.2 gb. 03.07.2018 45
4.1.1 Further maintenance
4.1.2 Lubrication of the linear guidance
WARNING
The gantry axis should be started up in set-up or jog mode.
Incorrect programming can trigger uncontrolled movements of
the gantry axis. Fast or unintentional movements of the module
can result in personal injury, even death, and damage to the
unit.
Ensure that the controller is switched off and secured against
being switched on again when working on the gantry axis.
 Every 2000 km or every 6 months to the carriage lubrication nipple (all 4)
2-3 bumps . Move the axis to a central position so that there is sufficient
spacing between the guide carriage and the limit stops to apply the grease
gun.
 Check whether the controller is switched off and secured against
restarting.

Remove old grease residues and dirt from the ends of the guide carriage with
a lint-free cloth
 Recommended grease types: Blasolube 301
In order to distribute the lubricant evenly, 2 – 3 strokes should be executed at low
speed after greasing is completed.
Under the ambient conditions mentioned below, the axis does not require any
further maintenance:
 clean workshop atmosphere
 no splash water
 no dust and fumes caused by abrasion or processes
 ambient conditions according to the technical catalogue
Lubrication on both sides of the carriage