![background image](http://html.mh-extra.com/html/danfoss/176f1784/176f1784_instructions_508185001.webp)
This instruction sheet is for the field installation of the USB extension cable into the door
of F-Frame VLT frequency converters.
Note: This kit is applicable to drives built dur-
ing or after Week 40 of 2008.
Frequency converters built prior to Week 40, 2008 do not
have the provisions for this kit.
INSTRUCTIONS
INSTALLATION OF USB EXTENSION CABLE INTO F-FRAME VLT
®
DRIVES
Instruction No: 177R0091 V0 Jan 2009 Page 1
VLT
®
is a registered trademark of Danfoss A/S
Kit Contents
•
USB extension cord
•
Tie wraps
•
Instruction Sheet 177R0091
Kit Part Number
176F1784
The door on the rectifier section of
F-Frame VLTs are fitted with a
feed-through hole to accommodate
a USB extension cord so that the
controls can be accessed from a
laptop computer without requiring
access to the inside of the VLT.
With the rectifier door open, the
hole is located near the upper right
corner of the door. See Figures 1
and 2.
The feed-through hole is covered
by the decorative label on the out-
side and with a round sticker on the
outside.
Figure 1. Location of USB feed-through hole.
WARNING
The frequency converter contains dangerous voltage. Disconnect power and follow lock-
out/tag-out procedures before working on this equipment.