21
Refer to the specific “Safety Regulation Manual” which is supplied enclosed with this manual (and which
forms an integral part of the same).
4.1
Machine area diagrams ..................................................................................................... 22
4.1.1 Safety devices ............................................................................................................ 23
4.1.2 Residual risk areas .................................................................................................... 25
WARNING
THE COMPONENTS YOU WILL BE USING CONTAIN ELEMENTS THAT MAY EXPOSE YOU TO
BOTH LOW AND HIGH-PRESSURE GAS STREAMS. GAS, EVEN UNDER MODERATE PRESSURE,
WILL CAUSE EXTREME BODILY HARM IF NOT TREATED WITH CARE.
DO NOT ALLOW ANY GAS STREAM TO BE DIRECTED AT ANY PART OF THEBODY. ANY HIGH-
PRESSURE HOSE END OR FITTING WILL CAUSE EXTREME HARM IF IT COMES LOOSE FROM
ITS RESTRAINT (OR TERMINATION) AND STRIKES ANY BODY PART. USE APPROPRIATE CARE
IN MAKING ALL CONNECTIONS.
Cautionary Operational Note:
This system contains automatic condensate drains. Use Auto Purge
feature to test for proper operation. However, when compressor is
in operation, open manual condensate drain bleeder valves at least
once a day to ensure that the auto drain is working properly.
Cautionary Operational Note:
DO NOT USE ANY FORM OF MINERAL OIL IN ANY
COMPRESSOR IN THIS SYSTEM. Use only EZ 1000 Compressor
Lubricant.
Cautionary Operational Note:
DO NOT USE THIS SYSTEM TO PRODUCE ABOVE 40% O
2
CONCENTRATION.
Cautionary Operational Note:
THE NITROGEN EXITING FROM THE NEEDLE VALVE MUST BE
VENTED OUTSIDE. SUFFOCATION AND DEATH CAN OCCUR
IF NITROGEN IS ALLOWED TO COLLECT IN AN ENCLOSED
SPACE.
Cautionary Operational Note:
When pumping nitrox, do not pump above 3700psi.
Cautionary Operational Note:
Temperature inside the Silent Tech 8 cabinet should never exceed
115 degrees F. Do not operate at that temperature.
Precautions for use and maintenance
PRECAUTIONS FOR USE AND
MAINTENANCE
4
Summary of Contents for MCH 14 TECH NITROX SERIES
