![background image](http://html.mh-extra.com/html/aeroqual/aqs-1/aqs-1_user-manual_2862866016.webp)
MRK-D-0048 V4
Aeroqual Dust Sentry / AQS User Guide
Page | 16
Powering monitor On/Off
NOTE: Pull the 12 VDC fuse
out from the fuse holder “off position” before testing the mains
connection. See Figure 2-8.
Online reference
http://training.aeroqual.com/mod/page/view.php?id=623
Online video
YouTube Channel: Aeroqual Service and Maintenance playlist
12 V
DC fuse pushed in, the “on” position
12 V DC fuse pulled out, the “off” position
Figure 2-8 The 12V DC fuse can be pulled out to turn off the monitor or pushed in to power the monitor
Push in the 12 DC fuse
to the “on” position as shown on the left in Figure 2-8.
The pump/s will start and the ePC will boot up with a series of beeps.
The green power LED lights should light up on the modules when power is applied, this confirms the
power is being correctly delivered to the modules.
2.6 Wiring auxiliary sensors
Online reference
http://training.aeroqual.com/mod/page/view.php?id=625
Online video
YouTube Channel: Aeroqual Service and Maintenance playlist
NOTE: To check the operation of the third party sensor in your office or laboratory prior to site
installation it is not required to feed the cable through the gland.
External sensors such as weather stations and noise meters need to be wired to the green connector
plug on the front of the auxiliary module. To connect third party sensors such as weather sensors,
feed the cable through a free cable gland and wire to the green plug.
AUX module
An AUX module is used to provide power to an external sensor and to process data
from the sensor. The AUX module is shown to the right.
The AUX module uses a 12 way green connector plug to connect to the external
sensor. The cable from the external sensor is passed through a waterproof gland on
the underside of the monitors and then connected to the green plug on the front of
the AUX module. Each third party sensor requires a different wiring configuration.
See 2.6.2 Auxiliary sensor wiring diagrams.
When you are happy with the wiring then apply power, and log on to the Aeroqual
Connect software as described in section 4.1 Aeroqual Connect (via Direct WIFI /
LAN). After some minutes you should see the parameters associated with the third party sensor being
shown in the software
in the APP “Configure Instrument”, view settings then the active sensor column.
To See the data, go to “Manage Data”, then Charts or Table, adjust the “Averaging Period” as
required.
NOTE:
Retain the certificate of compliance that is shipped with the monitor.